| Ich nutze: C164CI-ControllerBoard, eigenes Board, OSOPT V3.0 |
Ich habe Probleme den CAN-Bus auf 1Mb einzustellen
Benutzt wird das Modul Can.C2 2004 / 01 / 06
/********************************************************************
------------------------
DO NOT MODIFY THIS FILE!
------------------------
can.c2
C-Control II system access,
provided by Conrad Electronic, Germany
release : 2004/01/06
version : 1.2
author : mafoe
modified : by DIE HARD for C164 rev. DA compatibility (June 2003)
modified : André Helbig, little Bugfix in publish() (V1.11)
modified : Cris Ullmann, new function getID() (V1.2)
requires : vmcodes.c2
contents : CAN bus data transmission
*********************************************************************
This part is needed because Infineon changed some parts of
the CPU CAN-Module at the DA step of the C164CI development.
As an advantage of this change you get a speed of 1000 kbit/s
using the speed value 5
Compatibility: compatible downwards except speed 1000 kbit/s
}/********************************************************************
//-------------------------------------------------------------------
{inline vmcodes.VM_CAN | (vmcodes.CAN_INIT << 8);}
{ int psc;
//-------------------------------------------------------------------
inline function initold ( int speed, int globalMask, int specialMask )
//-------------------------------------------------------------------
{inline vmcodes.VM_CAN | (vmcodes.CAN_INIT << 8);}
// valid speed constants:
const SPEED_50 = 0;
const SPEED_62 = 1;
const SPEED_125 = 2;
const SPEED_250 = 3;
const SPEED_500 = 4;
//--------------------------------------------------------------------
Fehlt da nicht der Eintrag const SPEED_1000=5 ?
Beim Initialisieren wird immer 125 k bit gesetzt
//CAN-Bustiming 1000 kB/s
can.init(5,0x07FF,0x0000);
Da ich nur noch neue C-Controls ohne Gehäuse einsetze müsste jetzt alles klappen
weis Jemand dazu was ?
Gruss Dieter
Antwort schreiben
Antworten:
Re: Busspeed 1Mb (von Eberhardt weiss alles - 3.01.2006 11:48)